Sweeping magnet Shift
From Hall D Ops Wiki
Revision as of 10:27, 24 April 2017 by Deurpam (Talk | contribs) (Created page with "The sweeping magnet (DW002 dipole) in the alcove is used to clean-up the charged particles created at the collimators. Its operational current value should be set to I=190A....")
The sweeping magnet (DW002 dipole) in the alcove is used to clean-up the charged particles created at the collimators.
Its operational current value should be set to I=190A. This can be done using a magnet Slow Control GUI. Switch on the magnet using the magnet Slow Control GUI. Select "Input Select 1" on the main control GUI below the "Setpoint" window. Enter 150A. There is no need for hysteresis cycle.
Details about this magnet can be found here
