Difference between revisions of "July 22, 2009 CDC Meeting"
From GlueXWiki
(No difference)
|
Revision as of 10:01, 22 July 2009
- Action Items/Decisions from Previous Meeting
- Discussed high prices for tight tolerance components
- Checked IDEAL tool and manufacturing in Chicago. No listing
- Tim to discuss with vendor repair of end plates if hole messed up
- Carnegie Mellon to use GARFIELD to check electric field around crimp pin insert
- CMU to look over to see if piece tolerances can be loosened to ± .001 in
- These are ok for hole position. We had tightened them for gluing purposes.
- OK if we open end plate to .005 tolerance on hole positions, need to reduce straw diameter to prevent interferences
- Conductive rubber tubes cover 30% of gas holes - ok
- Add holes for 1/4 inch survey balls in top downstream plete to match upstream (2 at 90°)
- CMU to send list of glues
- Silver Epoxy: Tra-Con TRA-DUCT 2929
- Scotchweld 190 & 270
- JLAB to specify glue for rohacel to mylar joint
