Difference between revisions of "Private:UConn test setup"
From GlueXWiki
| Line 54: | Line 54: | ||
'''Setting up the setup''' | '''Setting up the setup''' | ||
| − | Connect keybord and monitor (if needed) to the Intel ROC. Connect upper LAN connector to the Ethernet cable | + | #* Connect keybord and monitor (if needed) to the Intel ROC. |
| + | #* Connect upper LAN connector to the Ethernet cable | ||
| + | #* Change ROC IP address (you will see the MAC address when you start booting the controller) | ||
| + | #* Login under '''halld''' | ||
Revision as of 18:33, 21 September 2012
Boards in the crate
| Board | Slot | Serial |
|---|---|---|
| CPU (halldtrg5) | 1 | |
| TI (Old) | 2 | |
| FADC250 | 5 | B21595_06R |
| SDC | 9 | |
| LE discriminator | 14 | C_15 |
| F1TDC | 16 |
Front pannel connections
| From | To |
|---|---|
| External trigger | TI input, IN1 |
| L1 Accept ( 3rd from the bottom ) | SDC TRG |
| L1 Accept ( 4 th from the bottom ) | F1TDC TRG |
| TI Out0 | F1TDC SYNC |
Setting up the setup
- Connect keybord and monitor (if needed) to the Intel ROC.
- Connect upper LAN connector to the Ethernet cable
- Change ROC IP address (you will see the MAC address when you start booting the controller)
- Login under halld
