Difference between revisions of "Gas leak tests"
From GlueXWiki
m (→Test of the feed-thru end plate glue joint) |
|||
Line 3: | Line 3: | ||
{| border="1" cellpadding="2" | {| border="1" cellpadding="2" | ||
|- | |- | ||
− | |width="415pt"|[[Image: | + | |width="415pt"|[[Image:leaktest1.jpg|thumb|none|400px|Gas vessel with 4 feed-thrus glued into (one side).]] |
− | |width="415pt"|[[Image: | + | |width="415pt"|[[Image:leaktest2.jpg|thumb|none|400px|Gas vessel with 4 feed-thrus glued into (one side).]] |
|- | |- | ||
|} | |} | ||
Line 10: | Line 10: | ||
No leaks were found. | No leaks were found. | ||
− | |||
= Preliminary conclusion = | = Preliminary conclusion = |
Latest revision as of 16:29, 18 February 2009
Test of the feed-thru end plate glue joint
No leaks were found.
Preliminary conclusion
After testing 2 glue joints that were found OK. All points towards the feed-thru donut glue joint. Apparently the tolerance is too high and needs to adjusted in the order of 1-0.5 mil. This needs to be further discussed.