Difference between revisions of "April 3, 2017"
From GlueXWiki
(Created page with "* ''' Loose end from the Spring 2017 run''' :: Final check of the fadc250 firmware ::: - Installed on all fadc crates :: F1TDC initialization issues (32 ns time shift) :: Und...") |
|||
(5 intermediate revisions by the same user not shown) | |||
Line 3: | Line 3: | ||
::: - Installed on all fadc crates | ::: - Installed on all fadc crates | ||
:: F1TDC initialization issues (32 ns time shift) | :: F1TDC initialization issues (32 ns time shift) | ||
− | |||
− | |||
− | |||
− | + | * ''' Topics for summer ''' | |
− | * ''' | + | :: Understanding (improving) performance at high rate |
− | :: | + | ::: - busy distribution (possible crashes at high data rate) |
− | :: | + | ::: - performance of CAEN TDCs |
− | + | :: Emulation of the trigger algorithm | |
− | + | :: Implementing SSP/GTP readout (Ben) | |
− | :: - | + | :: calibration constants for fadc250 (new firmware) |
− | ::: | + | :: further optimization of the L1 algorithm for high-lumi runs |
− | :: - | + | :: TOF trigger |
− | :: | + | ::: - already implemented (FDC alignment, hi-pt meson production) |
− | ::: | + | ::: - may require some modification (specs) |
− | ::: | + | ::: - test with Play Back |
− | ::: | + | :: F1TDC firmware modification |
− | :: - | + | ::: - (suppression headers) |
+ | :: L1 trigger simulation |
Latest revision as of 09:56, 3 April 2017
- Loose end from the Spring 2017 run
- Final check of the fadc250 firmware
- - Installed on all fadc crates
- F1TDC initialization issues (32 ns time shift)
- Final check of the fadc250 firmware
- Topics for summer
- Understanding (improving) performance at high rate
- - busy distribution (possible crashes at high data rate)
- - performance of CAEN TDCs
- Emulation of the trigger algorithm
- Implementing SSP/GTP readout (Ben)
- calibration constants for fadc250 (new firmware)
- further optimization of the L1 algorithm for high-lumi runs
- TOF trigger
- - already implemented (FDC alignment, hi-pt meson production)
- - may require some modification (specs)
- - test with Play Back
- F1TDC firmware modification
- - (suppression headers)
- L1 trigger simulation
- Understanding (improving) performance at high rate