Difference between revisions of "June 30, 2009 CDC Meeting"
From GlueXWiki
(→Notes) |
(→Notes) |
||
Line 31: | Line 31: | ||
* Crimp pin to plastic insert - CMU will think about the fit. | * Crimp pin to plastic insert - CMU will think about the fit. | ||
** Plastic inserts are all the same, make go 0.1" past the feed-thru.(Looks like 1.2). | ** Plastic inserts are all the same, make go 0.1" past the feed-thru.(Looks like 1.2). | ||
+ | ** Gary wants a slip interference fit. line-to-line fit. | ||
+ | |||
+ | * Plastic Insert | ||
+ | ** Want the counter-bored shoulder. | ||
+ | |||
* Donuts and feed through both have glue port and vent. | * Donuts and feed through both have glue port and vent. | ||
Line 36: | Line 41: | ||
* Depth of drilled holes changes (Noryl is 0.56", AL is 0.7"). | * Depth of drilled holes changes (Noryl is 0.56", AL is 0.7"). | ||
* Material for injection molding, HallB used glass-filled Noryl, What did Hall A use, does Eugene know? | * Material for injection molding, HallB used glass-filled Noryl, What did Hall A use, does Eugene know? | ||
− | * Get | + | * Get Mac-Master Carr part & grade for Noryl for donuts and feed thrus. |
+ | * |
Revision as of 12:23, 30 June 2009
Meeting Time and Place
Tuesday June 30 2009 at 11:00am At Jefferson Lab, the meeting will be held in room ARC 428
Connections
To connect from the outside, please use ESNET
1.) ESNET: 8542553
2.) Phone:
+1-800-377-8846 : US
+1-888-276-7715 : Canada
+1-302-709-8424 : International
then enter participant code: 39527048# (remember the "#")
Agenda
- CDC Endplate Drawings Drawings
- CDC Donut/Feedthru Drawings Donuts
Notes
- CDC Front Disc
- Section B-B, what is the small step? Small step to engage the inner hub.
- What will hold the inner tube to the end plates? Without the gas plenum, there is 3/8" on radius and after the polycarbonate, at least that much.
- OPEN How thick is ring on which inner tube is glued?
- Threaded inserts? These are for screwing in the gas plenum. Used in conjunction with the above mentioned groove to position plenum.
- Holes Sizes
- Crimp pin to plastic insert - CMU will think about the fit.
- Plastic inserts are all the same, make go 0.1" past the feed-thru.(Looks like 1.2).
- Gary wants a slip interference fit. line-to-line fit.
- Plastic Insert
- Want the counter-bored shoulder.
- Donuts and feed through both have glue port and vent.
- Feed through groove moved from 0.19 to 0.25" from tip on both Noryl and Al.
- Depth of drilled holes changes (Noryl is 0.56", AL is 0.7").
- Material for injection molding, HallB used glass-filled Noryl, What did Hall A use, does Eugene know?
- Get Mac-Master Carr part & grade for Noryl for donuts and feed thrus.