Difference between revisions of "Oct 13, 2011 SiPM Electrical and Cooling revised"
From GlueXWiki
(Created page with "== Action Items from previous meetings == # Carl to check instability of LED (as a possible contributor to sensor output changes) (Carl) # Chris to check HV specs on coax cable....") |
(→Action Items from previous meetings) |
||
| Line 1: | Line 1: | ||
== Action Items from previous meetings == | == Action Items from previous meetings == | ||
| − | # Carl to check instability of LED (as a possible contributor to sensor output changes) (Carl) | + | # <strike> Carl to check instability of LED (as a possible contributor to sensor output changes) (Carl) </strike> Jack confirmed the instability was related to low photoelectron yields |
| − | # Chris to check HV specs on coax cable. (Needs to hold at least 80 V). | + | # <strike> Chris to check HV specs on coax cable. (Needs to hold at least 80 V). </strike> Greater than 200 V rms, breakdown voltage of 640 V. |
== Tentative Agenda == | == Tentative Agenda == | ||
Revision as of 15:54, 13 October 2011
Action Items from previous meetings
-
Carl to check instability of LED (as a possible contributor to sensor output changes) (Carl)Jack confirmed the instability was related to low photoelectron yields -
Chris to check HV specs on coax cable. (Needs to hold at least 80 V).Greater than 200 V rms, breakdown voltage of 640 V.
Tentative Agenda
- Announcements
- Action Items
- Schedule, reporting, and manpower (Elton)
- SiPM testing (everyone)
- Light source / optics
- Electronic boards
- Cabling
- Cooling plate
- Other?
- Mechanical (Jim)
- Mechanical drawings (Chuck)
- Geometry (Elton)
- Temperature compensation (Jack)
- Preamp-summing (Fernando)
- Granularity (Elton)
Minutes
Attending:
