Difference between revisions of "Tagger Engineering Design"
Line 7: | Line 7: | ||
In general the drawing follow the design from Jim Kellie and G. Yang. Special care should be taken to avoid stress on the vacuum chamber and o-rings. Franz will provide a list of hot topics on the design discussed in the past. Richard will provide Sergey where to find all the relevant information on | In general the drawing follow the design from Jim Kellie and G. Yang. Special care should be taken to avoid stress on the vacuum chamber and o-rings. Franz will provide a list of hot topics on the design discussed in the past. Richard will provide Sergey where to find all the relevant information on | ||
the wiki. We will have a tagger-email list, which will have the list of people above pre-registered please tell your students or postdocs or .. to register so all the information is archived and all people are always informed. | the wiki. We will have a tagger-email list, which will have the list of people above pre-registered please tell your students or postdocs or .. to register so all the information is archived and all people are always informed. | ||
+ | |} | ||
+ | |||
+ | * '''Discussion and questions regarding the Serpukov tagger design drawings''' | ||
+ | {| align="right" width="95%" | ||
+ | | | ||
+ | ''Franz Klein'': The design effort should address the following areas of concern. | ||
+ | # Field and trajectory changes due to small misalignment of the magnets: this was answered in detail by Yang's simulation. | ||
+ | # Stress on vacuum chamber with 2 big magnets attached (relative motion of energized magnets and evacuated chamber). | ||
+ | # Sealing the large vacuum chamber at the contact with the magnets: large o-rings. | ||
|} | |} |
Revision as of 10:55, 25 April 2007
- Telephone meeting April 3, 2007 [Elke's notes]
Sergey will be at Jefferson lab 30.04-07 - 01.05.07, we will have a meeting on April 30th with Franz coming to JLAB and Richard and ? joining by video. Sergey will provide electronic versions of the drawing before this meeting to allow all people enough time to look to them and make remarks. |
In general the drawing follow the design from Jim Kellie and G. Yang. Special care should be taken to avoid stress on the vacuum chamber and o-rings. Franz will provide a list of hot topics on the design discussed in the past. Richard will provide Sergey where to find all the relevant information on the wiki. We will have a tagger-email list, which will have the list of people above pre-registered please tell your students or postdocs or .. to register so all the information is archived and all people are always informed. |
- Discussion and questions regarding the Serpukov tagger design drawings
Franz Klein: The design effort should address the following areas of concern.
|