Difference between revisions of "October 31, 2016"
From GlueXWiki
Line 15: | Line 15: | ||
:: ''' FADC 125 ''' | :: ''' FADC 125 ''' | ||
::: New firmware (Cody) | ::: New firmware (Cody) | ||
− | ::: No readout issues so far, some features with settings (reading out) thresholds | + | ::: No readout issues anymore (so far), some features with settings (reading out) thresholds |
::: (Cody is trying to fix now) | ::: (Cody is trying to fix now) | ||
::''' F1 TDC ''' | ::''' F1 TDC ''' |
Revision as of 09:35, 31 October 2016
- Status of the firmware update
- - FADC250
- processing version C04 since last week (minor issues, will be updated shortly),
- control versions: 81 (TAGM/TAGH), 41 all other crates
- most minor issues have been fixed
- - New CTP firmware on tagger crates (106, 307, and A03)
- do not update CTP firmware on other crates (may consider in the future, require some efforts)
- - New SSP firmware for TAGM/TAGH crates
- - New firmware versions for TIs (tip 61), TD (tdp 61)
- allows for busy distribution
- - New DSC firmware (version 0x10e)
- allows to set up bipolar thresholds
- installed on all crates except TOF
- is being currently tested
- FADC 125
- New firmware (Cody)
- No readout issues anymore (so far), some features with settings (reading out) thresholds
- (Cody is trying to fix now)
- F1 TDC
- new version exists (is being tested)
- more robust performance at high rate
- consider to install on some crates (TAGH) if time permits
- - FADC250
- Testing tagger trigger "
- checking performance using play back
- correct trigger bit/channel assignment (VXS back plane was replaced, new CTP firmware version)
- minor issues with FADC/CTP/SSP communication (will be fixed)
- check busy distribution
- - CTP/SSP, install check with TAGH
- - New fadc formats
- Modifications in initialization libs and config files
- - new initialization and config parameters for FADC250
- - config files for the play back
- - additions/reorganization of config files ( per channel DSC thresholds, etc.; any sub-detector groups requests)
- - configurations for stand alone daq
- L1 performance testing with the new firmware