Difference between revisions of "Real Gamma GDH Experiment (REGGE)"
From GlueXWiki
m (→Misc. Tasks and questions) |
(→Misc. Tasks and questions) |
||
Line 38: | Line 38: | ||
==Misc. Tasks and questions== | ==Misc. Tasks and questions== | ||
*<strike> Look into the figure of merit of the experiment in the low energy, where the photon beam polarization is low. (To see if constructing an additional tagger is justified). (A. Deur)</strike> | *<strike> Look into the figure of merit of the experiment in the low energy, where the photon beam polarization is low. (To see if constructing an additional tagger is justified). (A. Deur)</strike> | ||
− | |||
*How well can we check beam charge asymmetry with BPMs? | *How well can we check beam charge asymmetry with BPMs? | ||
*Effect of a beam position-helicity correlation on the data. (M. Dalton) | *Effect of a beam position-helicity correlation on the data. (M. Dalton) |
Revision as of 16:03, 19 March 2020
GDH wiki page
To connect from the outside by phone please do the following
- To join via a Web Browser, go to the page [1] https://bluejeans.com/433542984
- To join via Polycom room system go to the IP Address: 199.48.152.152 (bjn.vc) and enter the meeting ID: 433542984
- To join via phone, use one of the following numbers and the Conference ID: 433542984
- There is no moderator code
Dial Either +1 408 740 7256 or +1 888 240 2560 for US or Canada
Minutes of meeting
Documents
- Proposal:
- Misc
Misc. Tasks and questions
Look into the figure of merit of the experiment in the low energy, where the photon beam polarization is low. (To see if constructing an additional tagger is justified). (A. Deur)- How well can we check beam charge asymmetry with BPMs?
- Effect of a beam position-helicity correlation on the data. (M. Dalton)
- MC simulation:
- Produce background and main event rates.
- What trigger(s) to use and what would be its efficiency?
- Should a beam hardener be used?
- Check rates quoted in the proposal (once we decide on beam hardener. Presently, the rates are estimated with a 1 MeV cutoff on the photon flux distribution.
- Determine detection efficiency vs photon energy.
- Optimize experimental setup
- Update proposal with: (A. Deur)
- Add to the list of authors
- MC Simulation and set-up optimization
- Discussion about flipping target spin and beam 1/2-wave plate, see these minutes