May 5, 2011 SiPM Electrical and Cooling
From GlueXWiki
References
Action Items from previous meetings
- Check impact of material at low end of readout, both in the tubes for cooling fluid but also in the Cu cooling plate. Need to check effect on particle trajectories.
-
Suggested mods to mechanical: make SiPM holder one piece (instead of 4), increase thickness of holder to 3/16", increase length of heat spreader to cover all amplifiers. - Check bowing with FEA
- PCB dummy power load for thermal test.
Tentative Agenda
- Announcements
- Action Items
- Schedule, reporting, and manpower (Elton)
- SiPM testing (Carl and Yi)
- Mechanical (Jim)
- Mechanical drawings (Chuck)
- Geometry (Elton)
- Temperature compensation (Jack)
- Preamp-summing (Fernando)
- Will present a discussion of cabling and grounding next week.
Minutes
Attending: