Aug 9, 2011 SiPM Electrical and Cooling

From GlueXWiki
Revision as of 18:29, 9 August 2012 by Elton (Talk | contribs) (→‎Minutes)

Jump to: navigation, search

Action Items from previous meetings

  1. Develop front and back views of jumper sheets. (Jack)
    • This specifically includes the settings for the pre-production boards that are needed by Wed of next week.
  2. Test wrapping forms (Elton)
  3. Order glue (and any other consumables) to glue light guides (Scot)
  4. Check new gluing jig for the light guides (Scot and Jim)

Tentative Agenda

  1. Announcements
  2. Action Items
  3. Schedule, reporting, and manpower (Elton)
  4. SiPM production testing (everyone)
    • SiPMs assignment for new boards
  5. Mechanical assembly (Jim)
  6. Temperature compensation (Jack)
  7. Electronic boards (Chris)
  8. Light guide gluing setup (Scot via e-mail)
    • I have completed the redesigned light guide "push" vacuum wand / base fabrication as of 1:30 p.m. today.
    • I ordered a 1 LB. bottle of Norland NOA 87 light guide UV adhesive on 08/17/2012 - PR # 321682

Minutes

Attending: Jack, Elton, Jim, Eugene, Fernando, Ivan, Chris, Yi

  1. Announcements
  2. Action Items
  3. Schedule, reporting, and manpower (Elton)
    • Yesterday we received the second shipment of 600 SiPMs from USM. They sailed through customs
  4. SiPM production testing (everyone)
    • SiPMs assignment for new boards
    • Shaun Krueger (student from UofR) has made a list of 80 SiPMs to be fitted to the pre-production boards
    • Shaun has also compiled an assignment list of SiPMs to electronic boards for all 4000 sensors.
    • Shaun's approach is to group SiPMs according to Vop.
    • Replaced one R2 resistor with a fixed ~6KOhm resistor to compensate for low precision resistor value. Result is a 3 resistor trim, but covers the range needed
    • Pre-production boards will be different from the production boards to avoid changing many resistors. Only one resistor per SiPM needs to be changed on the pre-production board.
    • Final production units will have fixed values for the trim resistors, but different from the ones on the pre-production modules.
  5. Mechanical assembly (Jim)
  6. Temperature compensation (Jack)
    • Generated
  7. Electronic boards (Chris)
  8. Electronic boards (Fernando)
    • Need to find a good way of storing the SiPMs in preparation for installation
  9. Light guide gluing setup (Scot via e-mail)
    • I have completed the redesigned light guide "push" vacuum wand / base fabrication as of 1:30 p.m. today.
    • I ordered a 1 LB. bottle of Norland NOA 87 light guide UV adhesive on 08/17/2012 - PR # 321682
Retrieved from "https://halldweb.jlab.org/wiki/index.php?title=Aug_9,_2011_SiPM_Electrical_and_Cooling&oldid=39267"