GlueX TOF Meeting, June 13, 2017
GlueX Time-of-Flight Meeting
Tuesday, June 13, 2017
11:00 am EDT
JLab: CEBAF Center, Room F326/327
Contents
Agenda
- Announcements
- Review of minutes from the previous meeting
- Calibration Status
- Active Dividers
- Counter reconfiguration
- NIM Paper (Paul)
- Action Item Recap
Communication
- The BlueJeans Meeting number is 350 531 998.
- Enter BlueJeans Meeting
Slides
Talks can be deposited in the directory /group/halld/www/halldweb/html/talks/2017
on the JLab CUE. This directory is accessible from the web at https://halldweb.jlab.org/talks/2017/ .
Minutes
Present:
- FSU: Sasha Ostrovidov
- JLab: Thomas Britton, Brad Cannon, Eugene Chudakov, Mark Ito (chair), Simon Taylor, Beni Zihlmann
There is a recording of this meeting on the BlueJeans site.
Review of minutes from the previous meeting
We went over the minutes from May 30.
Beni mentioned that although he completed calibration pass through the Spring 2017 data with fine run segmentation, he has not revised the calibrations constants, derived from a previous pass, in the CCDB. We are very close to the final configuration for the next launch and there have been no problems reported with the current set of constants. His current plan is to hold off on updating the CCDB for now.
Calibration Status
Brad and Beni have been reviewing our calibration procedures. Two areas could potentially improve performance.
Time-Walk Correction
Beni is switching to a scheme where pulse amplitude is used in the walk correction rather than pulse integral area.
The current functional form does not do a great job of fitting the data. Beni is trying a fit to two independent regions of time vs. amplitude to get a better representation of the data. The next step is testing to see if there is any improvement.
Energy Calibration
Brad is looking into a repeat of our energy calibration. Though the energy measurement from the TOF is not a critical quantity, the calibration has not been done for a while and needs an update.