Difference between revisions of "Analysis Plan"
From GlueXWiki
m |
|||
Line 1: | Line 1: | ||
'''Calibration Tasks''' | '''Calibration Tasks''' | ||
+ | #''Tagger'' (Tyler) | ||
+ | #* | ||
+ | #''FCAL'' (Igal) | ||
+ | #* | ||
+ | #''CCAL'' (Drew) | ||
+ | #*<del>Timing offsets</del> | ||
+ | #*Timewalk calibration | ||
+ | #*Gain calibration | ||
+ | #*Nonlinear energy correction | ||
− | '''Analysis Tasks''' | + | ---- |
+ | |||
+ | '''General Analysis Tasks''' | ||
#''Alignment of detectors/beam. '' (Drew, 1 week) | #''Alignment of detectors/beam. '' (Drew, 1 week) | ||
#*Compton on inner part of FCAL to align FCAL with beam. | #*Compton on inner part of FCAL to align FCAL with beam. | ||
Line 10: | Line 21: | ||
#''Matching of detector response in Data/Simulation'' (Igal) | #''Matching of detector response in Data/Simulation'' (Igal) | ||
− | '''Compton Analysis''' | + | ---- |
− | # | + | |
+ | '''Compton Analysis''' (Drew) | ||
+ | #Perform simulations for 2021 data set. | ||
#*Simulate both Compton (signal) and Pair production (background) in hdgeant4 | #*Simulate both Compton (signal) and Pair production (background) in hdgeant4 | ||
#*May need separate simulations for each run period to account changes in run conditions. | #*May need separate simulations for each run period to account changes in run conditions. | ||
+ | #Determine optimal cut widths for each cut parameter (deltaE, deltaPhi, etc.) | ||
+ | #Measure cross section for small run periods | ||
+ | #Systematics study |
Revision as of 13:57, 19 November 2021
Calibration Tasks
- Tagger (Tyler)
- FCAL (Igal)
- CCAL (Drew)
Timing offsets- Timewalk calibration
- Gain calibration
- Nonlinear energy correction
General Analysis Tasks
- Alignment of detectors/beam. (Drew, 1 week)
- Compton on inner part of FCAL to align FCAL with beam.
- Use single-arm Compton scattering to align CCAL with beam.
- Determine angular resolution of two-photon pairs. (Tyler)
- Study how the resolution changes with energy and scattering angle
- Can use pi0s at larger angles and extrapolate to forward-angles
- Matching of detector response in Data/Simulation (Igal)
Compton Analysis (Drew)
- Perform simulations for 2021 data set.
- Simulate both Compton (signal) and Pair production (background) in hdgeant4
- May need separate simulations for each run period to account changes in run conditions.
- Determine optimal cut widths for each cut parameter (deltaE, deltaPhi, etc.)
- Measure cross section for small run periods
- Systematics study