Difference between revisions of "Analysis Plan"
From GlueXWiki
| Line 9: | Line 9: | ||
#*Gain calibration | #*Gain calibration | ||
#*Nonlinear energy correction | #*Nonlinear energy correction | ||
| + | |||
---- | ---- | ||
| Line 20: | Line 21: | ||
#*Can use pi0s at larger angles and extrapolate to forward-angles | #*Can use pi0s at larger angles and extrapolate to forward-angles | ||
#''Matching of detector response in Data/Simulation'' (Igal) | #''Matching of detector response in Data/Simulation'' (Igal) | ||
| + | |||
---- | ---- | ||
Revision as of 13:58, 19 November 2021
Calibration Tasks
- Tagger (Tyler)
- FCAL (Igal)
- CCAL (Drew)
Timing offsets- Timewalk calibration
- Gain calibration
- Nonlinear energy correction
General Analysis Tasks
- Alignment of detectors/beam. (Drew, 1 week)
- Compton on inner part of FCAL to align FCAL with beam.
- Use single-arm Compton scattering to align CCAL with beam.
- Determine angular resolution of two-photon pairs. (Tyler)
- Study how the resolution changes with energy and scattering angle
- Can use pi0s at larger angles and extrapolate to forward-angles
- Matching of detector response in Data/Simulation (Igal)
Compton Analysis (Drew)
- Perform simulations for 2021 data set.
- Simulate both Compton (signal) and Pair production (background) in hdgeant4
- May need separate simulations for each run period to account changes in run conditions.
- Determine optimal cut widths for each cut parameter (deltaE, deltaPhi, etc.)
- Measure cross section for small run periods
- Systematics study
