Difference between revisions of "CDC High Voltage Board (HVB)"

Latest revision as of 16:58, 13 May 2008

Version 3 can be downloaded here:

cdcpcbv3.tgz

Now been taken over by Kim

A representation can be seen in figure 2.1. Note: this is a 3D representation: the grounding plane is not shown and the (blue) RC devices are meant to be SM (if you look close enough you can see the SM pads) but are not shown as such (there was no 3D representation available for SM devices).

figure 2.1: A 3D representation of the HVB.

The HV connector will most likely be:

Tyco: 1218055-1 surface mount on the HVB side

Tyco: 448660-1 on the cable side

The LV/test-signal/T-readout cable will most like be:

Erni: 214014 surface moutn on the HVB side

Erni: SFX with 8 conductors on the cable side