Difference between revisions of "HOWTO Run Gluex Software with a GCC 8 module"
From GlueXWiki
(Created page with "The following assumes that you are using the bash shell. tcsh can be used as well with appropriate modifications. == Log into the ifarm at JLab == == Enable GCC 8 == modul...") |
(→Enable GCC 8) |
||
| Line 6: | Line 6: | ||
module use /apps/modulefiles | module use /apps/modulefiles | ||
| − | module load gcc/8. | + | module load gcc/8.4.0 |
export CC=`which gcc` | export CC=`which gcc` | ||
export CXX=`which g++` | export CXX=`which g++` | ||
Latest revision as of 15:59, 14 November 2023
The following assumes that you are using the bash shell. tcsh can be used as well with appropriate modifications.
Log into the ifarm at JLab
Enable GCC 8
module use /apps/modulefiles module load gcc/8.4.0 export CC=`which gcc` export CXX=`which g++`
This sets you up to use GCC 8.3.0. To check, to a "gcc --version".
Set Up the GlueX Environment
source /group/halld/Software/build_scripts/gluex_env_boot_jlab.sh gxenv $HALLD_VERSIONS/version_beta_1.0.xml
This is no different than usual.
Run hd_root
hd_root
You should see the usage message. From this point forward, things should be like a normal session on the ifarm, except that not all of the packages you normally see on the ifarm proper are available in the container.
