Difference between revisions of "July 26, 2019 FCAL Insert Design Meeting"
From GlueXWiki
(→Decisions/Action items) |
|||
| Line 23: | Line 23: | ||
== Decisions/Action items == | == Decisions/Action items == | ||
* We will go with the 40x40 matrix for the design, we will have to shim if the install changes to 32x32 | * We will go with the 40x40 matrix for the design, we will have to shim if the install changes to 32x32 | ||
| + | * Need to define rohacell | ||
| + | * Need to define monitoring system | ||
| + | * Need to define tungsten absorber geometry | ||
| + | * Need to perform heat load calcs | ||
| + | * Need to define cable management system | ||
| + | * Need to define shim material | ||
Revision as of 12:53, 29 July 2019
Meeting Time and Place
Friday July 26,2019 1pm At Jefferson Lab, room TED 2504
Agenda
- Discuss 40x40 vs 32x32 crystal assembly
- 32x32 crystal matrix layout Media:32x32_crystal_matrix_2D_layout.pdf
- 40x40 crystal matrix layout Media:40x40_crystal_matrix_2D_layout.pdf
- Decision to pre-measure stacks of crystals and the existing FCAL to determine bottom row offsets
- Shimming of row above crystals may be needed
- Discuss installing Rohacel US of crystals to fill hole and support the lead glass blocks
- Rohacel properties Media:Rohacel cut sheet.pdf
- Discuss Tungsten absorber
- How many crystals does it cover?
- How to support it and the blocks above
- Monitoring System
- Is acrylic sheet good enough for crystals?
- How were original FCAL lead glass modules stacked?
- Matt Shepherd stated that they were rotated 90 degrees every other one and bottom row was shimmed as required.
- What should the shim material be
Decisions/Action items
- We will go with the 40x40 matrix for the design, we will have to shim if the install changes to 32x32
- Need to define rohacell
- Need to define monitoring system
- Need to define tungsten absorber geometry
- Need to perform heat load calcs
- Need to define cable management system
- Need to define shim material
