Difference between revisions of "Minutes 10-4-2006"

Revision as of 08:58, 13 December 2006

FDC Weekly Meeting

Date: October 4, 2006

Participants: Daniel, Brian, Simon

Next Meeting: Wednesday, October 18, 2006 @ 1:30 p.m.

1). Brian reported that the materials for the full-scale cathode

   tensioning system have arrived.  He will ask the shop to construct
   the device once we are ready.
 - Brian asked that we verify that the largest possible diameter of
   the active cathode area is 1.2 m.  We verified this from Ravi's
   latest mechanical drawing.

2). The wire circuit board will consist of circuit board tiles laminated

   on a g10 backing.  Brian (and Chris Cuevas) believe that this will
   give us the most flexibility in choosing a vendor and will not  
   give us any problems in precision as dowel pins will be used to
   define the relative positioning.

3). Brian has continued to work on the mechanical design and the wire

   plane design.
  - The wire plane circuit board will be divided into a signal side
    and a HV side.
  - The current design consists of a frame with a 3 in (approx)
    annulus ==> 103 sense wires, 104 field wires.

4). The Rohacell order finally is signed and out the door.

5). Brian believes his mechanical drawings are nearly far enough along

   to give to the Electronics Group for design.  DSC believes that
   we should not rush this forward.  We need to work on such areas
   as the gas distribution design for the chambers to reduce the
   number of design iterations.

6). We need to think about the on-chamber cooling system for the

   electronics.

7). We discussed how to attach the FDC layers within a package.

   Currently we have ~48 ``threaded rods".  This is necessary to
   compress the o-rings.  DSC asked Brian to consider a ``quick"
   disconnect system to enable access to the chamber faster.  Brian
   suggested a cam-type securing bolt that could be easily released.

8). Simon reported that HDFast is really broken. DSC asked Simon if

   he could use an old version.  Simon will look into this.

9). It is not clear what copper thickness we have on our flex boards

   for the cathodes.  1/4 oz vs. 1/2 oz?  Brian and Simon will look
   into this (check the order form that Randy Wojcik put together).

10). Meet in two weeks after the GlueX Collaboration meeting.

Minutes prepared by Daniel. Send any comments or corrections along.