Difference between revisions of "November 19, 2014 Calibration"

From GlueXWiki
Jump to: navigation, search
(Agenda)
(Minutes)
Line 67: Line 67:
 
Simon has found that the quality of the reconstructed tracks with the field off is problematic and this is leading to problems matching to BCAL hits.  The matching with the field on is fine.  He is looking into this.
 
Simon has found that the quality of the reconstructed tracks with the field off is problematic and this is leading to problems matching to BCAL hits.  The matching with the field on is fine.  He is looking into this.
  
 +
===TOF===
 +
 +
Sasha O. has been working on the TOF calibration primarily with cosmic data, and has been starting to analyze photon beam data.  He's looked at run 995, but this did not have TDC information.  Hopefully the data taken over the past night will be more useful.  The fADC pulse integrals are also not understood.
 +
 +
===Start Counter===
 +
 +
 +
Lubomir asked if Eric was calculating the TDC times in reference to the trigger signal.  Eric said he was not since he didn't know how to get at this information.  Lubomir said that he would email Eric about how to get that information.
 
   
 
   
# Calibration status/updates
+
===Simulations===
## FCAL
+
 
## BCAL - [[November_19,_2014_Calibration_BCAL_email_from_Zisis | email from Zisis]]
+
 
## CDC
+
===Data Monitoring===
## FDC
+
## TOF
+
## Start Counter - [http://argus.phys.uregina.ca/gluex/DocDB/0026/002606/001/ST_CCDB_Update.pdf ST CCDB Update]
+
# [[Fall 2014 Commissioning Simulations]] updates
+
# Data Monitoring
+

Revision as of 14:25, 19 November 2014

GlueX Calibration Meeting
Wednesday, October 22, 2014
11:00 am, EDT
JLab: CEBAF Center, F326

Connection Using Bluejeans

  1. To join via Polycom room system go to the IP Address: 199.48.152.152 (bjn.vc) and enter the meeting ID: 630804895.
  2. To join via a Web Browser, go to the page [1] https://bluejeans.com/630804895.
  3. To join via phone, use one of the following numbers and the Conference ID: 630804895
    • US or Canada: +1 408 740 7256 or
    • US or Canada: +1 888 240 2560
  4. Upon connection all microphones are automatically muted. To unmute your mike on a Polycom or equivalent unit, enter *4
  5. More information on connecting to bluejeans is available.

Agenda

  1. Announcements
  2. Status Update
  3. Calibration status/updates
    1. FCAL
    2. BCAL - email from Zisis
    3. CDC
    4. FDC
    5. TOF
    6. Start Counter - ST CCDB Update
  4. Fall 2014 Commissioning Simulations updates
  5. Data Monitoring
    1. Commissioning Software
    2. Run Browser, Plot Browser, and Time Series webpages
    3. Discussion of results (Kei)
  6. AOB

Minutes

Attending: Sean (NU); Kei, Simon, Lubomir, Mark I., Justin, Nathan S., Will McG., Naomi, Mike S. (JLab); Paul (CMU); Eric (FIU)

Status Updates

The target conditions are being tracked as a function of run, and in the process a problem where the run number wasn't always being saved in the EVIO files was found and fixed.

We then reviewed the status of various subdetectors.

BCAL

We reviewed an email from Zisis. Mark D. extracted the attenuation lengths. Will M. is working on pi0 reconstruction. Tegan is looking at the thresholds in various runs. Andrei is extracting the fADC to physical unit calibration using cosmic data.

No pi0 peaks are found yet. The beam data studies are statistically limited.

FDC

Lubomir reported that last night they took several hours of data with the solenoid turned off. The data looked to be of good quality, with many reconstructed tracks. This data is allowing him to take a preliminary look at the alignment, e.g. the rotations of the different packages. Vlad has been looking at the cathode strip calibration using cosmic data, and he is starting to use the same technique with the new beam data. Preliminary results are encouraging.

The TDC readout for the wires is still a problem, which is limiting the obtainable time resultion, and hindering the calibration of the time-to-distance functions.

Simon has been analyzing the data and has posted several plots to the logbook. He is looking at matching tracks to other detectors. Matching to the start counter and FCAL is working well, and he has been able to image the start counter. For the FCAL, right now he can only match to hits not clusters. He is not able to match to the TOF hit positions.

Having a BCAL trigger would be useful for getting tracks that illuminate more of the FDC. Having tracks from the active target is useful as well. Simon's made several plots of track vertex location, and sees what looks like some tracks coming from active target.

10-20% of the tracks look like they come from the beam halo or interactions in the air.

CDC

Naomi and Mike said that they have taken data at three high voltage settings as part of a scan to find the best high voltage set point.

Simon has found that the quality of the reconstructed tracks with the field off is problematic and this is leading to problems matching to BCAL hits. The matching with the field on is fine. He is looking into this.

TOF

Sasha O. has been working on the TOF calibration primarily with cosmic data, and has been starting to analyze photon beam data. He's looked at run 995, but this did not have TDC information. Hopefully the data taken over the past night will be more useful. The fADC pulse integrals are also not understood.

Start Counter

Lubomir asked if Eric was calculating the TDC times in reference to the trigger signal. Eric said he was not since he didn't know how to get at this information. Lubomir said that he would email Eric about how to get that information.

Simulations

Data Monitoring