Revision as of 21:32, 16 September 2014

Scope

Below we discuss the procedures necessary to operate the GlueX Start Counter (ST) EPICS GUI in order to operate the Low Voltage (LV) and Bias power supplies.
In order to operate the ST from outside the Hall or the Hall D counting house the user will must obtain a Two-Factor Authorization (TFA) device from the Jefferson Lab (JLab) IT help desk.

Obtain a physical authentication token
Download the Cryptocard app
You must obtain the TFA in person from the IT help desk. The help desk will provide either depending on the users preference.

Begin by ssh'ing into the JLab network in the usual fashion and enter your password.

ssh -X user@login.jlab.org

ssh -X user@hallgw

Now you must ssh into one of the gluon servers (gluon29, gluon51, etc) under the username hdops.

ssh -X hdops@gluon##

@@ Line 8: / Line 8: @@
 ::* You must obtain the TFA in person from the IT help desk.  The help desk will provide either depending on the users preference.
 * In order to operate the Start Counter EPICS GUI do the following:
-# ssh into JLab
+# Begin by ssh'ing into the JLab network in the usual fashion and enter your password.
   ssh -X user@login.jlab.org
+# Next ssh into into the hall gateway and enter your TFA password.
+ ssh -X user@hallgw
+# Now you must ssh into one of the '''gluon''' servers (gluon29, gluon51, etc) under the username '''hdops'''.
+ ssh -X hdops@gluon##
+:* Password is '''GlueX_2come'''