Photographs of corrosion and surface defects

Photographs of flaws in the Allflex films were taken when the boards arrived in September '08 and again in March '09 after being stored in a dry Nitrogen environment. The first two photographs below show that there was already evidence for corrosion or poor quality of the copper surface on one of the 5 micron boards when they arrived from the manufacturer, but it is not clear that this problem became worse over time.

figure 1a: Photograph of 5micron/Left#2 flaw taken 09/08.

figure 1b: Photograph of 5micron/Left#2 flaw taken 03/09.