Difference between revisions of "Private:UConn test setup"
From GlueXWiki
| Line 55: | Line 55: | ||
* Connect keybord and monitor (if needed) to the Intel ROC. | * Connect keybord and monitor (if needed) to the Intel ROC. | ||
| − | * Connect | + | * Connect Ethernet cable to the upper ROC LAN connector. |
* Change ROC IP address (you will see the MAC address when you start booting the controller) | * Change ROC IP address (you will see the MAC address when you start booting the controller) | ||
* Login under '''halld''' | * Login under '''halld''' | ||
Revision as of 10:13, 24 September 2012
Boards in the crate
| Board | Slot | Serial |
|---|---|---|
| CPU (halldtrg5) | 1 | |
| TI (Old) | 2 | |
| FADC250 | 5 | B21595_06R |
| SDC | 9 | |
| LE discriminator | 14 | C_15 |
| F1TDC | 16 |
Front pannel connections
| From | To |
|---|---|
| External trigger | TI input, IN1 |
| L1 Accept ( 3rd from the bottom ) | SDC TRG |
| L1 Accept ( 4 th from the bottom ) | F1TDC TRG |
| TI Out0 | F1TDC SYNC |
Setting up the setup
- Connect keybord and monitor (if needed) to the Intel ROC.
- Connect Ethernet cable to the upper ROC LAN connector.
- Change ROC IP address (you will see the MAC address when you start booting the controller)
- Login under halld
