Difference between revisions of "Private:UConn test setup"
From GlueXWiki
| Line 65: | Line 65: | ||
* '''/home/halld/micro/coda''' contains Run Control data base | * '''/home/halld/micro/coda''' contains Run Control data base | ||
* '''/home/halld/data''' is a directory for the DAQ data storage. The external drive has to be mounted to here | * '''/home/halld/data''' is a directory for the DAQ data storage. The external drive has to be mounted to here | ||
| + | * '''/home/halld/micro/coda_micro_setup''' is a script with configuration variables | ||
| + | ** you have to edit this file ad change some variables if needed | ||
| + | ** '''source coda_micro_setup''' to set variables up | ||
''' How to run DAQ ''' | ''' How to run DAQ ''' | ||
''' Change electronics boards initialization parameters ''' | ''' Change electronics boards initialization parameters ''' | ||
Revision as of 11:21, 24 September 2012
Boards in the crate
| Board | Slot | Serial |
|---|---|---|
| CPU (halldtrg5) | 1 | |
| TI (Old) | 2 | |
| FADC250 | 5 | B21595_06R |
| SDC | 9 | |
| LE discriminator | 14 | C_15 |
| F1TDC | 16 |
Front pannel connections
| From | To |
|---|---|
| External trigger | TI input, IN1 |
| L1 Accept ( 3rd from the bottom ) | SDC TRG |
| L1 Accept ( 4 th from the bottom ) | F1TDC TRG |
| TI Out0 | F1TDC SYNC |
Setting up the setup
- Connect keybord and monitor (if needed) to the Intel ROC.
- Connect Ethernet cable to the upper ROC LAN connector.
- Change ROC IP address (you will see the MAC address when you start booting the controller)
- Login under halld
Directories
- The home directory is /home/halld
- /home/halld/micro/rol contains the F1TDC configuration file and the link to the DAC readout list (see descriptions below)
- /home/halld/micro/coda contains Run Control data base
- /home/halld/data is a directory for the DAQ data storage. The external drive has to be mounted to here
- /home/halld/micro/coda_micro_setup is a script with configuration variables
- you have to edit this file ad change some variables if needed
- source coda_micro_setup to set variables up
How to run DAQ
Change electronics boards initialization parameters
