Reconstruction To Do List

Generation
1. Use genr8 for a2 production
2. Skim off (hd_filter) the wanted events by cutting on the total neutral energy (> 6 GeV) but record the total number of events before skimming. The resulting MC data set will be stored for general use.
3. Use Pythia for background generation after removing a₂ → η π⁰ from the MC data stream
4. Use a2 charge exchange production xsection vs pythia total xsection to estimate number of signal and noise events
Analysis
1. After pruning the Pythia events, check the generated vs. reconstructed energy in a plot.
2. Look at the a2 mass peak - adjust cuts on the eta and pi0 masses then look at the effect on the different angular distributions (i.e. Gottfried-Jackson angles, etc.)
3. look at difference between reconstructed and generated z position for less than 65 cm
4. look at single photon reconstruction efficiencies
5. adjust the error matrix for the BCAL (look in PID/DPhoton_factory.cc)
Gather all relevant DocDB documents and cross section publications at one spot on the Wiki.

Documents to Review

Simultaneous Photoproduction of eta and pi0 Mesons on the Proton, PRL 100, 052003 (2008) DOI:10.1103/PhysRevLett.100.052003
- Pertinence:
- Abstract: The analysis of the γp → η π0 p reaction has been performed using data from the GRAAL experiment. The total and differential cross sections and the beam asymmetry have been obtained from threshold up to 1.5 GeV of beam energy. The two resonances S11(1535) and Δ(1700) are expected to be excited in the intermediate states of this reaction. The results are used to test predictions based on the assumption that both resonances are dynamically generated from the meson-baryon interaction provided by chiral Lagrangians. The term involving the Δ(1700) excitation, followed by the decay into ηΔ(1232), is found to be dominant.