Difference between revisions of "Testing High Granularity Hodoscope"
From GlueXWiki
(→Layout) |
(→Procedure) |
||
| Line 1: | Line 1: | ||
==Procedure== | ==Procedure== | ||
| − | + | <b> Low Voltage/ Bias Control</b> | |
| + | <br> | ||
| + | <br> | ||
| + | In preparation for the tests, set-up the WIENER power supply (readout power and bias supplies) under computer control.<br> | ||
| + | The readout supplies (channels 0 and 1 of the 8008L module) should be set to 5V and the bias supplies (channels 0 through 4 of the ISEG module)<br> | ||
| + | should be set to the respective bias operating voltages from the SiPM channel chart. | ||
| + | <br> | ||
| + | <br> | ||
==Testing Silicon Photomultipliers== | ==Testing Silicon Photomultipliers== | ||
Revision as of 13:36, 17 June 2015
Procedure
Low Voltage/ Bias Control
In preparation for the tests, set-up the WIENER power supply (readout power and bias supplies) under computer control.
The readout supplies (channels 0 and 1 of the 8008L module) should be set to 5V and the bias supplies (channels 0 through 4 of the ISEG module)
should be set to the respective bias operating voltages from the SiPM channel chart.
