Difference between revisions of "Check beam position at the tagger dump"
From Hall D Ops Wiki
(Created page with "=== Monitor Temporary CARMs=== The position at the tagger dump can be monitored using BPM AD00. To monitor them: # Open Hall-D CSS EPICS Control if not already available fo...") |
(No difference)
|
Revision as of 18:02, 22 October 2014
Monitor Temporary CARMs
The position at the tagger dump can be monitored using BPM AD00.
To monitor them:
- Open Hall-D CSS EPICS Control if not already available following instructions.
- From Main Action Bar, click General GlueX Overview in GENERAL section.
- The tagger dump BPM readouts are on the top near the middle of the screen, indicated by the ellipses in the figure.