Difference between revisions of "Check beam position at the tagger dump"
From Hall D Ops Wiki
(Created page with "=== Monitor Temporary CARMs=== The position at the tagger dump can be monitored using BPM AD00. To monitor them: # Open Hall-D CSS EPICS Control if not already available fo...") |
(→Monitor Temporary CARMs) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
The position at the tagger dump can be monitored using BPM AD00. | The position at the tagger dump can be monitored using BPM AD00. | ||
| Line 8: | Line 6: | ||
# From '''Main Action Bar''', click '''General GlueX Overview''' in '''GENERAL''' section. | # From '''Main Action Bar''', click '''General GlueX Overview''' in '''GENERAL''' section. | ||
# The tagger dump BPM readouts are on the top near the middle of the screen, indicated by the ellipses in the figure. | # The tagger dump BPM readouts are on the top near the middle of the screen, indicated by the ellipses in the figure. | ||
| − | [[File: | + | [[File:Read_dump_bpm.jpg|700px|thumb|center| BPM readouts are indicated by the ellipse in the General GlueX Overview epics screen ]] |
Latest revision as of 18:03, 22 October 2014
The position at the tagger dump can be monitored using BPM AD00.
To monitor them:
- Open Hall-D CSS EPICS Control if not already available following instructions.
- From Main Action Bar, click General GlueX Overview in GENERAL section.
- The tagger dump BPM readouts are on the top near the middle of the screen, indicated by the ellipses in the figure.
