Difference between revisions of "August 4, 2010 Tracking CDC/FDC"
From GlueXWiki
m (→Agenda) |
|||
Line 26: | Line 26: | ||
## Our pneumatic glue injection supplier also supplies epoxies (Elsworth Adhesives). We have gotten a better price for our conducting epoxy from them. The glue is also sold in a better dispenser system -- basically a dual cartridge syringe with a very short mixing chamber. They also have a shorter (10 day) lead time than McMaster Carr. <b>Cheaper price, less waste, quicker mixing.</b> | ## Our pneumatic glue injection supplier also supplies epoxies (Elsworth Adhesives). We have gotten a better price for our conducting epoxy from them. The glue is also sold in a better dispenser system -- basically a dual cartridge syringe with a very short mixing chamber. They also have a shorter (10 day) lead time than McMaster Carr. <b>Cheaper price, less waste, quicker mixing.</b> | ||
## We have 50/50 AR-CO<sub>2</sub> premix.[[Premixed_50/50]] | ## We have 50/50 AR-CO<sub>2</sub> premix.[[Premixed_50/50]] | ||
− | ## Update on noise studies with the new preamplifier ([ | + | ## Update on noise studies with the new preamplifier ([http://halld.org/CDC/faraday/index.html Caged prototype]). [[Noise_studies]] |
# AOT | # AOT | ||
== Minutes == | == Minutes == |
Revision as of 11:08, 4 August 2010
Meeting Time and Place
Wednesday August 4, 2010 at 11:00am At Jefferson Lab, the meeting will be held in room F326-327
Connections
To connect from the outside, please use ESNET
1.) ESNET: 8542553
2.) Phone:
+1-800-377-8846 : US
+1-888-276-7715 : Canada
+1-302-709-8424 : International
then enter participant code: 77438230# (remember the "#")
Agenda
- Announcements
- FDC Update logbook
- CDC Update
- Update on the new straws (Pictures).
- The scratches are gone.
- Acceptance rate has been 104 out of 108 straws. After cutting open the four rejects, we concluded that three also would have been acceptable. The one failure is a glueball on the straw (we are writing the paper now).
- The straws are much cleaner than anything we have seen before - just a few white spots - so we are looking modifying our cleaning procedure.
- Lamina told us the straws are manufactured in a clean room and any dust we see can only be mylar dust ( and we do not see very much at all).
- Lamina is going to do production with an interior carton so we can clear all the packing material away before opening the inner case.
- Our pneumatic glue injection supplier also supplies epoxies (Elsworth Adhesives). We have gotten a better price for our conducting epoxy from them. The glue is also sold in a better dispenser system -- basically a dual cartridge syringe with a very short mixing chamber. They also have a shorter (10 day) lead time than McMaster Carr. Cheaper price, less waste, quicker mixing.
- We have 50/50 AR-CO2 premix.Premixed_50/50
- Update on noise studies with the new preamplifier (Caged prototype). Noise_studies
- Update on the new straws (Pictures).
- AOT