Difference between revisions of "Bill's to do list"
From GlueXWiki
(→2018) |
(→2019) |
||
| Line 18: | Line 18: | ||
==2019== | ==2019== | ||
| + | * Temperature reduction for the DIRC FPGAs. | ||
| + | * Water quality setup, 3D printing the box. | ||
| + | * Darkening. | ||
| + | * Uni-strut reinforcement for the distribution boxes. | ||
| + | * Airflow sensor | ||
| + | *Opening both DIRC boxes in January: | ||
| + | ** Check mirror quality | ||
| + | ** Check anodize quality | ||
| + | ** Check water tightness of the diffuser assembly. | ||
| + | *North Box: | ||
| + | **Check corner interference. | ||
| + | **Silicone around the wielding spot. | ||
| + | *South Box: | ||
| + | **Check the chipped corner water seal for both spots | ||
==2020== | ==2020== | ||
Revision as of 12:58, 31 January 2020
2018
- Priority list:
- Laser alignment and generating mis-alignment table (Bill, Andrew).
- Feedthrough opening angle measurement and fish tank (Bill, Fernando).
- Light monitors testing and mounting (Bill, Keith).
- DIRC module cabling strategy (Bill/Andrew).
- Hole opening on the backplate (Keith).
- Hole opening on the of the PMT mounting plate (Tim, Keith, Bobby).
- Plastic bolts and screws for the FPGA board. (Chris)
- Recover PMT #9 and 10 and perform test
- Spare micro-BNC cable for the big box. (Omen)
- Cleaning of the mirrors. (Greg, Keith)
- Remarking and repositioning the Fiber cable label. (Fernando/Chris)
- PMT mounting plate spacer (Bobby)
- Installation tray. (Mark/Keith)
- Installation spacer. (Bobby)
2019
- Temperature reduction for the DIRC FPGAs.
- Water quality setup, 3D printing the box.
- Darkening.
- Uni-strut reinforcement for the distribution boxes.
- Airflow sensor
- Opening both DIRC boxes in January:
- Check mirror quality
- Check anodize quality
- Check water tightness of the diffuser assembly.
- North Box:
- Check corner interference.
- Silicone around the wielding spot.
- South Box:
- Check the chipped corner water seal for both spots
