Bill's to do list

2018

1. Priority list:
   • Laser alignment and generating mis-alignment table (Bill, Andrew).
   • Feedthrough opening angle measurement and fish tank (Bill, Fernando).
   • Light monitors testing and mounting (Bill, Keith).
   • DIRC module cabling strategy (Bill/Andrew).
   • Hole opening on the backplate (Keith).
   • Hole opening on the of the PMT mounting plate (Tim, Keith, Bobby).
   • Plastic bolts and screws for the FPGA board. (Chris)
   • Recover PMT #9 and 10 and perform test
   • Spare micro-BNC cable for the big box. (Omen)
   • Cleaning of the mirrors. (Greg, Keith)
   • Remarking and repositioning the Fiber cable label. (Fernando/Chris)
   • PMT mounting plate spacer (Bobby)
   • Installation tray. (Mark/Keith)
   • Installation spacer. (Bobby)

2019

• Temperature reduction for the DIRC FPGAs.
• Water quality setup, 3D printing the box.
• Darkening. &#10004
• Uni-strut reinforcement for the distribution boxes.&#10004
• Airflow sensor &#10004
• Opening both DIRC boxes in January:
  • Check mirror quality &#10004
  • Check anodize quality &#10004
  • Check water tightness of the diffuser assembly. &#10004
• North Box:
  • Check corner interference. &#10004
  • Silicone around the wielding spot.&#10004
• South Box:
  • Check the chipped corner water seal for both spots