Bill's to do list

2018

1. Priority list:
   • Laser alignment and generating mis-alignment table (Bill, Andrew).
   • Feedthrough opening angle measurement and fish tank (Bill, Fernando).
   • Light monitors testing and mounting (Bill, Keith).
   • DIRC module cabling strategy (Bill/Andrew).
   • Hole opening on the backplate (Keith).
   • Hole opening on the of the PMT mounting plate (Tim, Keith, Bobby).
   • Plastic bolts and screws for the FPGA board. (Chris)
   • Recover PMT #9 and 10 and perform test
   • Spare micro-BNC cable for the big box. (Omen)
   • Cleaning of the mirrors. (Greg, Keith)
   • Remarking and repositioning the Fiber cable label. (Fernando/Chris)
   • PMT mounting plate spacer (Bobby)
   • Installation tray. (Mark/Keith)
   • Installation spacer. (Bobby)

2019

1. Temperature reduction for the DIRC FPGAs.
2. Water quality setup, 3D printing the box.
3. Darkening. ✓
4. Uni-strut reinforcement for the distribution boxes. ✓
5. Airflow sensor ✓
6. Opening both DIRC boxes in January:
   • Check mirror quality ✓

• • Check anodize quality ✓
  • Check water tightness of the diffuser assembly. ✓

1. North Box:

• • Check corner interference. ✓
  • Silicone around the wielding spot. ✓

1. South Box:

• • Check the chipped corner water seal for both spots

2020 Summer DIRC list

• Darkening leak check