Difference between revisions of "Calibration-Monitoring"
From GlueXWiki
(→Calibration and Monitoring System) |
|||
Line 3: | Line 3: | ||
These pages describe the R&D and choices for the calibration and monitoring system for the calorimeters and possibly other detector systems. | These pages describe the R&D and choices for the calibration and monitoring system for the calorimeters and possibly other detector systems. | ||
+ | === April 15, 2009: Update === | ||
+ | [http://argus.phys.uregina.ca/cgi-bin/private/DocDB/ShowDocument?docid=1236 LED board layout] | ||
+ | |||
+ | === September 02, 2008: Update === | ||
+ | [http://argus.phys.uregina.ca/cgi-bin/private/DocDB/ShowDocument?docid=1092 GlueX-doc-1092] | ||
+ | |||
+ | === May 2008 Collaboration Meeting === | ||
+ | |||
+ | * [http://argus.phys.uregina.ca/cgi-bin/private/DocDB/ShowDocument?docid=1059 Status report on the UoA calibration system tests] | ||
+ | * [http://argus.phys.uregina.ca/cgi-bin/private/DocDB/ShowDocument?docid=1051 Summary LED Measurements] | ||
+ | |||
+ | [http://www.jlab.org/Hall-D/software/wiki/index.php/Sep_2%2C_2008_Calorimetry#Calibration_Specifications_Table Calibration Specifications Table] for BCAL, FCAL, TOF and START | ||
=== Initial System Concept === | === Initial System Concept === | ||
Line 13: | Line 25: | ||
[[Media:LED_Pulser_Control_Module.pdf]] | [[Media:LED_Pulser_Control_Module.pdf]] | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− |
Revision as of 09:45, 15 April 2009
Contents
Calibration and Monitoring System
These pages describe the R&D and choices for the calibration and monitoring system for the calorimeters and possibly other detector systems.
April 15, 2009: Update
September 02, 2008: Update
May 2008 Collaboration Meeting
Calibration Specifications Table for BCAL, FCAL, TOF and START
Initial System Concept
The content in the three attachments below was presented by the Athens group on May 5, 2008.