Difference between revisions of "Jun 30, 2011 SiPM Electrical and Cooling"
From GlueXWiki
(→Action Items from previous meetings) |
(→Action Items from previous meetings) |
||
| Line 5: | Line 5: | ||
# Check impact of material at low end of readout, both in the tubes for cooling fluid but also in the Cu cooling plate. Need to check effect on particle trajectories. | # Check impact of material at low end of readout, both in the tubes for cooling fluid but also in the Cu cooling plate. Need to check effect on particle trajectories. | ||
# Fernando will check son SEMTEC cable assemblies. | # Fernando will check son SEMTEC cable assemblies. | ||
| − | # Calculate acceptance for various heights of the flat section (Elton). | + | # <strike> Calculate acceptance for various heights of the flat section (Elton). </strike> |
== Tentative Agenda == | == Tentative Agenda == | ||
Revision as of 16:19, 29 June 2011
References
Action Items from previous meetings
- Check impact of material at low end of readout, both in the tubes for cooling fluid but also in the Cu cooling plate. Need to check effect on particle trajectories.
- Fernando will check son SEMTEC cable assemblies.
-
Calculate acceptance for various heights of the flat section (Elton).
Tentative Agenda
- Announcements
- Action Items
- Schedule, reporting, and manpower (Elton)
- SiPM testing (Carl and Yi)
- Mechanical (Jim)
- Mechanical drawings (Chuck)
- Geometry (Elton)
- Temperature compensation (Jack)
- Preamp-summing (Fernando)
Minutes
Attending:
