Difference between revisions of "Monitoring System Requirements"
From GlueXWiki
| Line 27: | Line 27: | ||
# Details: [http://www.jlab.org/Hall-D/software/wiki/index.php/Dec_06%2C_2010_Calibration/Monitoring Minutes/notes from December 6, 2010] | # Details: [http://www.jlab.org/Hall-D/software/wiki/index.php/Dec_06%2C_2010_Calibration/Monitoring Minutes/notes from December 6, 2010] | ||
| − | # Comment: | + | # Comment: time and temperature stability of system is very important. |
| − | # Comment: Option of delivering a range of light intensities important (e.g. using various filter settings). Athens | + | # Comment: Option of delivering a range of light intensities important (e.g. using various filter settings). Athens will test stability of LEDs at low output (near threshold) to see if this can be used as an additional check point in our monitoring. Double LED system (one UV and one blue) per light guide will be investigated. |
| − | # Comment: | + | # Comment: LED system could be very useful for the Start Counter. |
Revision as of 18:09, 8 December 2010
| Characteristic | LED/fibre | LED/wire |
|---|---|---|
| Dead/alive or on/off | yes | yes |
| Timing check/offset | yes | yes |
| Relative gain check | yes | yes |
| Linearity check | low end (a few times one LED) only | low end (a few times one LED) only |
| Temperature stability | yes, sensors in box | sensors in areal spread? |
| Tower row flashing | yes, multiplexer | yes, multiplexer |
| Simultaneously flash both ends | no solution yet | no solution yet |
| Location of LEDs input | Boxes at outer edge of each module, fibres | LED+board on light guide, LPCM in rack |
| Geometrical constraints | mechanical/fragility/replacement are serious concerns | none; easy to install |
| R&D done | Some, solution not preferred | Extensive, mature solution exists |
| Cost | Not costed | quotation exists (getting stale) |
- Details: Minutes/notes from December 6, 2010
- Comment: time and temperature stability of system is very important.
- Comment: Option of delivering a range of light intensities important (e.g. using various filter settings). Athens will test stability of LEDs at low output (near threshold) to see if this can be used as an additional check point in our monitoring. Double LED system (one UV and one blue) per light guide will be investigated.
- Comment: LED system could be very useful for the Start Counter.
