Difference between revisions of "Photon Reconstruction in b1pi events 02/10/2012"
From GlueXWiki
(→Cuts) |
(→Two gamma invariant Mass) |
||
Line 35: | Line 35: | ||
==Two gamma invariant Mass== | ==Two gamma invariant Mass== | ||
− | Look at pairs of 2 BCAL photons | + | Look at pairs of 2 BCAL photons. Using truth vertex information. |
+ | |||
+ | Later should add FCAL photons. | ||
Compare KLOE algorithm to GlueX algorithm. | Compare KLOE algorithm to GlueX algorithm. | ||
Line 41: | Line 43: | ||
[[Image:photon_two_gamma_invariant_mass_.png]] | [[Image:photon_two_gamma_invariant_mass_.png]] | ||
− | Black is KLOE, red is GlueX | + | Black is KLOE, red is GlueX. |
− | + | ||
− | + |
Revision as of 19:15, 13 February 2012
BCAL
Thrown photons
Look at the distribution of decay photons from the pi0.
For comparison with reconstructed data, useful to look at z rather than theta. This is the z that the photon would reach the inner radius of the BCAL, given its momentum and vertex.
Reconstructed photons
Spectrum of reconstructed "photons": exclude clusters that can be matched to a charged track.
Where does each of these peaks come from?
- Peaks at upstream and downstream ends of detector from noise that cause garbage timing info?
- Other three sharp peaks? Look like FDC structure, but spacing is not right?
Cuts
- A timing cut fabs(t_shower-t_flight) < 1 ns can be applied to remove many of the extra "photons". (Red curve below)
- I don't think low energy showers are well understood at the moment, so remove clusters with E<60 MeV. (Green)
- Also, cut out a problem area at forward angles and lower energies (E<120 MeV && z>325 cm) (Blue)
More work needed to optimize cuts.
With all cuts:
Number of "photons" decreases from 44,000 to 13,000.
Two gamma invariant Mass
Look at pairs of 2 BCAL photons. Using truth vertex information.
Later should add FCAL photons.
Compare KLOE algorithm to GlueX algorithm.
Black is KLOE, red is GlueX.