Offline Monitoring Data Validation
From GlueXWiki
This page contains the procedure for checking if production runs are of good quality and can be used for physics analysis.
Run Periods
- RunPeriod-2016-02 Validation
- RunPeriod-2016-10 Validation
- RunPeriod-2017-01 Validation
- RunPeriod-2018-01 Validation
- RunPeriod-2018-08 Validation
Procedure
For each production run, do the following:
- Go to the | Offline Run Browser page.
- Follow the steps outlined in the checklist below.
- Certify that each section is okay
- (DB + script to be developed)
- Set run status = 1 in RCDB
- (script provided)
Run Statuses
- -1 - unchecked
- 0 - rejected (not physics-quality)
- 1 - approved
- 2 - approved long/"mode 8" data
- 3 - calibration / systematic studies
Checklist
Reference run for 2017-01: 30780
Reference run for 2018-01: 40933/4
Reference run for 2018-08: 51388
- BCAL
- CDC
- FCAL
- FDC
- SC
- TOF
- RF
- Check timing offsets - Reference: [ link ]
- Should be centered around zero
- Check timing offsets - Reference: [ link ]
- Timing
- Check Calorimeter Timing - Reference: [ link ]
- Check Drift Chamber Timing - Reference: [ link ]
- Check PID System Timing - Reference: [ link ]
- Check Tagger Timing - Reference: [ link ]
- Check Track Matched Timing - Reference: [ link ]
- Check Tagger/RF Timing - Reference: [ link ]
- Check Tagger/SC Timing - Reference: [ link ]