Search results

Create the page "High Voltage" on this wiki! See also the search results found.

• Primer for shift takers
  <td bgcolor="#e0e0f0"> All High Voltage ok? check box for, BCal, FCal, CDC, FDC, TOF, ST, PS, TagM, TagH </td> <td bgcolor="#e0e0f0"> [[Primer high voltages table]] </td>
  17 KB (2,895 words) - 05:48, 22 January 2023
• Spring 2015 6GeV Commissioning Plan
  #*LH2 target, high priority. (<span style="color:fuchsia"> Expected time: ?? (Estimated 28h #*Diamond radiator/goniometer, high priority. (<span style="color:fuchsia"> Expected time 80h </span>)
  19 KB (2,941 words) - 16:48, 17 April 2015
• Time-of-Flight System Expert
  ==Verifying optimal high-voltage settings==
  6 KB (1,074 words) - 19:54, 19 November 2015
• Forward Calorimeter Shift Comissioning Era
  To avoid damaging PMTs from high rates near the center of the beam pipe the FCAL will be turned on in 3 stag ...e the darkroom. Each of the 2800 bases are equipped with temperature, high voltage, and current sensors. The following instructions are for non-experts during
  9 KB (1,587 words) - 14:08, 27 February 2017
• DIRC Shift
  ...sor is located beneath the optical box which will disable the low and high voltage in the case of a water leak. ...system while the bases are powered off. An interlock on the low and high voltage to the electronics and PMTs protects the readout system from damage. A pro
  6 KB (1,033 words) - 09:41, 22 March 2023
• Compton Calorimeter Shift
  ...le and the detector expert should be notified. The HV parameters, such as voltage settings and trip currents cannot be changed by the shift worker. The crew should set the voltage on the PMT using the GUI interface (see instructions below). If the problem
  3 KB (553 words) - 20:23, 28 November 2022
• Short Term Run Plan
  If FCAL HV bases lose communication and stop providing high voltage, refer to https://halldweb.jlab.org/hdops/wiki/index.php/Forward_Calorimete
  4 KB (617 words) - 04:49, 13 February 2023